
RV & Boat Storage Pole Barns in Lubbock, TX | Tall Doors, Pull-Through Bays and Lockable Steel
We start RV and boat storage pole barns in Lubbock at the door and work outward. At Pole Barn Builders Lubbock TX we do it in that order for a reason. The door height sets the header. The header sets the eave. The eave sets what every post in the building costs. Get that one number wrong by a foot and nothing else on the drawing will rescue it.
Hail is the reason most of these buildings get built in the first place. Fifty or so hail days a year land in this radar area, with May the worst month and June behind it. A fiberglass cap or a gel coat has no answer to any of them. An enclosed bay with a door that shuts is the only version that keeps blowing hail and grit off a rig. A roof on posts lets both of them in from the side. Send the measured height and length. Tell us the room you have outside to turn in. We will work the bay and the door out together.
Get a quote on your building
Professional RV and Boat Storage Pole Barns in Lubbock Start at the Tape Measure
Measure to the tallest thing on your rig: air conditioners, antennas, satellite domes, the mast. Plenty of motorhomes and fifth-wheels stand over 13 feet with the units on top. A 12-foot door that looked fine on paper stops the rig dead at the opening. Send us that measurement, not the brochure height. We will check it against the door before anything gets ordered.
Length catches people the same way. Add the tongue or hitch on an RV trailer. Add the whole trailer under a boat. Then add walking room at both ends. The door has to close behind the thing. The overhead tracks and opener eat into the headroom inside. We draw all of that out before we size a bay.
How a Tall Door Pulls on the Header, the Posts and the Footings
Header, then eave
A tall opening wants a header deep enough to carry the roof load around it. We stack the track and the opener above that header. Your eave lands well above the clear opening. In the gable end the roof pitch gives you some of that height.
Width and the posts either side
Widen the door and load moves onto the jamb posts, then into the footings under them. Shallow caliche takes a rock auger. Caliche at five feet puts the bearing deeper.
Which wall it goes in
A gable-end door leaves both sidewalls whole. A sidewall door takes a full bay out of one. Doors are also how buildings like this get lost. The frame is engineered at 107 mph with the building shut. A gust front arrives with the big door up, the inside flips from external to internal pressure, and the walls push out while the roof lifts. Close it when weather is coming.
Seals at the bottom and the jambs
Dust finds any gap around a door. A bottom seal closing onto an uneven slab leaves one the full length of the opening. Fine sand comes through it. We pour the slab edge flat where the door lands. Closures at the laps and weatherstripping at the jambs finish it.
Pull-Through or Back-In, One Bay or Several, and the Caliche Approach
How you plan to drive in sets the shape of the bay. We ask that before anything gets sized.
- Pull-through or back-in
A pull-through bay with a door at each end is far easier to drive, and it costs you two large doors. Back-in takes one door and turning room outside it. Flat section ground usually has that room. A parcel with a playa in the low corner may not, since the ground you would turn on is the ground that holds water.
- One bay or several
One wide bay stays flexible for whatever you buy next. Separate bays with their own doors mean the boat comes out without moving the motorhome first. We price both. Then the gap is in front of you.
- Apron and approach
Caliche is what the drives out here are built from, and a well-compacted caliche base in front of the door holds up under a rig. Loose sand ruts and then it will not hold a turn. We check the approach against the turning radius of your longest unit. Where the room is not there, we say so before you order.
- Inside clearance
Clear height under the trusses is one number. Height under the lights and the door tracks is another. Roof units on a motorhome need room above the door line once the rig is inside. We measure both. We order a door once both numbers are in hand.
Hail, 3,200 Hours of Sun and a Shore Power Circuit for the Rig

One storm is all it takes. Hail cracks a fiberglass roof and dents a trailer. Stones of four and a half inches have come down on this town. Add about 3,200 hours of sun a year working on your gel coat and rubber seals. An enclosed building stops both. An open-sided shelter costs less and lets blowing hail and dust reach the rig anyway.
We pull a circuit for a battery tender or shore power while the walls are still open. A 30 or 50 amp outlet costs almost nothing now and a great deal later. Tell us if you plan to wash the rig inside. We will slope the slab to a drain while the concrete is still a drawing.
Locks, Lighting and Keeping Air Moving Through a Lubbock Summer
- Locks and lighting
A stored motorhome or boat is one of the more valuable things on your place. Solid doors and decent locks make it a harder target. So does a light over the approach.
- Ventilation
We fit a ridge vent. Soffit or wall inlets get sized to feed it. A steel building shut up through a Lubbock summer runs far hotter inside than out. Air that keeps moving is what holds mildew off upholstery.
- Moisture
A rig can sweat inside a closed building even when nothing on it is leaking. Keep your vents open. For long-term storage a dehumidifier is worth the plug it occupies.
- Floor drain
Washing the rig indoors means sloping the slab to a drain. What is legally allowed to go down one is worth asking before we form the floor.
Axle Loads, Landing Gear and Bracketed Posts Under an RV Storage Slab
Axle load is the number that decides this floor. A loaded motorhome puts far more through each tire patch than a car does. A fifth-wheel on its landing gear concentrates it into four small pads. Give us the axle count, the loaded weight if your paperwork carries it, and roughly where the jacks come down.
We bracket some of these posts to the slab instead of embedding them, and the slab is then part of the wind load path. It is a structural decision, not a flooring upgrade. Tires parked in one place for months are the other load, and concrete carries them better than a gravel pad that ruts. We keep the apron flat at the door and pitch the rest away from the building.
Storage Bay Questions From Motorhome and Boat Owners Around Lubbock
How tall should the door be for a Class A motorhome?
Measure your own unit with everything on the roof included, then add clearance above that. A 14-foot door is a common answer, and many tall motorhomes sit near 13 and a half. The tape measure decides, not the average. Send us the model and the measured height. We will check it against the door.
Can I store a boat and an RV in the same building?
Yes, as long as the bays and the doors are sized for both of them. Separate bays with their own doors nearly always beat one shared door. Share a door and getting your boat out means moving the motorhome first.
Does an RV storage building need to be insulated?
Not for storage on its own. Plenty of owners skip it. Insulation and ventilation together bring the heat and the condensation down. That matters if the rig sits for long stretches, or if you work on it in there.
What floor works best?
Concrete stays cleanest and is kinder to tires sitting in one spot for months. Gravel costs less and wants maintenance. Either way it has to be graded to drain. We set that slope when we build the pad.
Can I store a boat with a tall tower or mast?
Yes, given a tall enough door. Measure the boat on its trailer with the tower folded into its storage position. Add clearance on top of that figure before you let anybody order a door.
Should the bay be insulated?
For bare storage, no. Insulation starts paying if you work on the rig inside. It also pays if you want the heat held off sensitive electronics and upholstery through a run of 96 degree days.
Who is the best company for RV and boat storage pole barns in Lubbock, TX?
Here is the checklist we work from. We size the door off your measured roof height and not off the brochure. We check the clear height under trusses and tracks as a separate number. We rough in the 30 or 50 amp circuit while the walls are open. The floor slope goes in then too. Site visits are billable and we say so up front. Ask the next company you call for the measured door height and the inside clear height both. See whether they give you two numbers or one.
Covered Storage Buildings We Raise in Tahoka, Wolfforth and Woodrow
We put up storage in Tahoka, Wolfforth, Woodrow, Abernathy, Brownfield, Denver City. Measure the tallest unit including the air conditioner before you send the size.
Measured Height Over the Roof Units, and the Length Over the Hitch
Send us the measured height over the roof units and the length over the hitch. Tell us where on the parcel it goes and what the approach is made of. We will size the doors and the bays, then price it.
