
Local Livestock Barns in Lubbock, TX | Loafing Sheds, Working Pens and Winter Windbreaks
At Pole Barn Builders Lubbock TX we build livestock barns in Lubbock and across the South Plains to suit the animals you keep, not a standard shed size. Send the species and the head count. Tell us how the building gets worked through the year. We lay out how much of the wall stays open. We place the partitions, the creep areas, the holding pen. The fence line, the alleys, the loading point all tie into the building, not against it.
Animals lean, rub, kick. Steel panel within reach of them dents inward. It works the fasteners loose until the sheet is hanging on by its washers. We back the lower wall with a solid kick wall of treated lumber or concrete. The steel starts above it. That keeps the panel out of reach. It gives you a surface a skid steer can scrape against without tearing the building apart. Tell us what you are running and where the site is. We will lay the shed out and price it from there.
Get a quote on your building
Livestock Barns Near Lubbock Matched to Species, Head Count and Season
Cattle on pasture mostly want shade in summer and a windbreak in winter. An open-fronted loafing shed gives both for less than an enclosed barn costs. Goats, sheep, hogs usually want more enclosure and bedding. Sometimes heat too, particularly through kidding, lambing or farrowing. Dairy and confined feeding run well past a simple shed. We will say so plainly if that is what you are describing to us. We will also tell you where a shed stops being the right building for it.
Start with the species and the head count. Tell us how the building gets used across the seasons. Those three decide how much of the wall stays open. They decide whether partitions, creep areas or a holding pen belong in the plan. We would far rather have them before the drawing than after it.
Airflow, Gate Posts in Caliche, Handling Pens and Cleaning the Barn
- Airflow
Heat and ammonia collect under the roof of a closed barn. A ridge vent only works where the eave inlets feed it. We cut the inlets to match the ridge opening.
- Posts and gates in caliche
A pen layout puts more holes in the ground than the building does. Every gate post has to reach the same caliche the building posts do, and that layer starts anywhere from roughly thirty inches down to sixty. We auger the pen line with the footprint. A rock auger or a breaker gets through where a dirt bit quits.
- Handling
We lay the fence line, the sorting pens and the loading point out alongside the shed, not next year. Gates go in easier before the building stands, on posts set to carry the hinge.
- Manure and cleaning
Think through how the barn gets cleaned before we draw it. A floor sloped to a drain saves labor every week. So does a surface a skid steer can scrape without catching. Where a loaded feed truck comes inside, the slab gets designed to that axle.
Stock Through a 96 Degree Summer and a 15 Degree Lubbock Winter
Winter design here is 15 degrees, summer design 96. Your stock lives through both ends.
- Summer
Shade does most of the work. Summer design wet bulb here is 69, so the air is dry even when it is hot. Air moving through an open shed beats fans in a closed one. We run the sidewall high enough for heat to climb off them.
- Winter
A solid back wall and solid ends break the north wind. Dry bedding on a dry floor does more for most stock than heat will. We close the north end first.
- Wet weather
Mud does the damage, not the rain total. Most of it lands in May and June, in storms. A pad built above the lot keeps feet and bedding dry. We cut the lot so water leaves it.
- Open sides
A tall open-sided barn loads differently from a closed one. We tell the engineer which sides stay open before the roof is designed. Flat grazing ground with nothing tall on it is Exposure C, which loads a frame harder than a sheltered town lot does.
Grading the Lot and Checking the Playa Flood Zone Before We Site It

A lot that holds water becomes mud. Mud brings hoof and health trouble along behind it. Grading takes care of it. We fall the pad and the surrounding lot so rain leaves the building and leaves the ground the animals stand on. We carry the roof runoff away with it. We cut the lot to fall away from the feeding line as well. A big roof sheds a great deal of water in very little time.
We check the mapped flood zone before helping you settle on a spot. Plenty of South Plains sites sit near playas. A playa fills after heavy rain and spreads wider than the basin looks. There is no bank to mark the edge. The City of Lubbock's floodplain guidance warns about exactly that.
Who Reviews a Cattle Barn in Unincorporated Lubbock County, and Who Does Not
In unincorporated Lubbock County nobody issues a general construction permit, and there is no zoning. We confirm which side of the line your parcel sits on before quoting. Engineering is voluntary out there, and it shows up in financing and insurability before compliance. The county handles septic, floodplain and county roads. An ag valuation is a property-tax question, not a building permit. Those get conflated constantly.
What Years of Stock Traffic Do to Screws and Laps on a West Texas Shed
We walk a livestock shed looking harder at the fasteners than at the panel. On R-panel the screws sit in the flat, an inch and a quarter below the rib, with ribs every 12 inches. The EPDM washer under the head goes brittle in this much sun. A screw backing out of a lower sheet turns from a drip into a sharp edge at exactly the height stock push past it.
Corners and gate openings take the rest of the wear, because stock funnel through them. We sheet those stretches in 26-gauge, which is the dent-resistant gauge, and not in 29. We run the panel laps the way the animals move, so a shoulder pushes a lap closed instead of open.
Running Water Below the 12-Inch Frost Line and Draining the Feed Line
Water lines freeze here in a hard winter. The frost line sits at 12 inches. So the supply to a waterer goes below that. The riser gets protected where it comes up out of the ground. We set the waterers on ground that falls away from them. We keep them clear of the line the animals stand on to feed. A trough on flat ground makes its own mud hole inside a week.
Feeding wears the ground harder than anything else on the place. We grade the feed line so water leaves it. We build the apron firm enough to carry a loaded feed truck in wet weather. We get the gates and the alley in while the loader is already on site. Every one of those costs less done right the first time. Afterward you are working around a herd that already uses the building.
Questions Ranchers Ask About Loafing Sheds, Summer Heat and Playa Ground
Is an open-fronted loafing shed enough for cattle in winter?
For many beef operations, yes. A solid back and side walls break the wind. A deep roof keeps the animals dry. Calving or sick animals want something more enclosed with bedding. We can work that bay into the same shed while the frame is being designed. We bed it deep. We gate it off the main run.
How do I keep a livestock barn from overheating in summer?
Shade, open sides, a ridge vent, eave inlets. Those do most of it. Roof slope and overhangs add to that. Setting the building so the prevailing southerly passes straight through does too. Orientation does the rest wherever the site leaves a choice.
Can I convert part of a livestock barn for storage later?
Yes, where the frame was built to take it. The slab as well. Say up front that feed or equipment storage might take over an end. Then we size the posts and the footings for that from the beginning.
What should I check before building near a playa lake?
Floodplain status, the flood elevation and the soil. The soil here is clay that swells and shrinks with moisture. We look at all three before recommending a pad location. We set the floor above the flood elevation we find. The pad is the one decision you cannot revisit afterward.
How much space does each animal need?
That depends on the species and the size. It also depends on how long they spend inside. Your veterinarian, the extension office or the program you sell into will give you the guidelines. Send us the numbers. We lay the shed out to match them.
Can a livestock barn double as storage?
Yes, and many owners give one end over to feed or equipment. Keep feed and hay out of the animal area. That holds down dust and spoilage, and it holds down fire risk. We will fire-separate that end if you want the separation built in.
Who is the best company for livestock barns in Lubbock, TX?
That is yours to weigh, so weigh this. We grade the pad and the lot so water leaves the ground the animals stand on. That decision reaches the engineer before anything gets drawn. We set the gates with the building, not after it. The alleys and the loading point go in at the same time. And we check the floodplain and playa situation on your parcel. Ask the next builder you call how they handle those four and compare.
Species, Head Count and Which Sides of the Shed Stay Open
Species, head count, and which sides you want left open. Tell us where on the place it goes. We draw the shed and put a price on it.
